Applicable Regulations
Method Statement — Sequence of Work
- Review this RAMS and confirm site conditions match those described before work begins.
- Brief all operatives on the hazards, controls and PPE requirements below (toolbox talk).
- Check and don all required PPE, and inspect tools and equipment before use.
- Carry out the task in line with the control measures set out in the Hazard & Risk Assessment section below.
- Maintain good housekeeping throughout — keep the work area tidy and manage waste and materials safely.
- On completion, remove tools and equipment, restore the work area, and report any incidents, near misses or changes in site conditions to the site supervisor.
- Complete the sign-off section at the end of this document before leaving site.
Hazard & Risk Assessment
Each hazard is assessed against a standard Likelihood × Severity matrix. “Initial Risk” reflects the risk before any control measures are applied; “Residual Risk” reflects the risk once the stated controls are correctly implemented on site.
Electric Shock During Appliance Connection
Control: Isolate the relevant circuit before hard-wiring any appliance, and visually inspect flexible connections and plugs before use.
Water Leaks from Plumbed Appliance Connections
Control: Use correctly rated hoses and fittings for washing machines and dishwashers, and pressure test connections before leaving site.
Manual Handling of Heavy Appliances
Control: Use an appliance trolley and correct lifting technique for washing machines, dishwashers and ovens, particularly on stairs.
Manoeuvring Appliances on Stairs & Through Doorways
Control: Assess the access route and use an appliance trolley or straps before attempting to move heavy appliances up stairs or through tight doorways.
Old Appliance Removal & Disposal
Control: Disconnect and remove old appliances safely, disposing of them via a licensed WEEE-compliant waste carrier.
Required PPE
Emergency Procedures
Fire
Stop work immediately, raise the alarm and evacuate to the designated assembly point. Do not attempt to fight a fire beyond your training. Call 999 once safely evacuated if the fire brigade has not already been alerted.
First Aid / Injury
Stop work and alert the nearest first aider or site supervisor. For a serious injury, call 999 immediately and do not move a casualty unless there is immediate danger.
Spillage / Environmental Incident
Stop work, contain the spill using the site's spill kit if safe to do so, and report it to the site supervisor immediately. Do not allow any spillage to enter a drain or watercourse.
Frequently Asked Questions
Does this RAMS cover gas-connected appliances such as cookers?
The RAMS includes general connection safety controls, but any gas appliance connection must be carried out by a Gas Safe registered engineer separately, in line with the Gas Safety (Installation and Use) Regulations 1998.
Do I need to keep a copy of this RAMS on site?
Yes. HSE guidance expects a copy of the RAMS — along with the completed sign-off section — to be available on site for the duration of the work, and reviewed if site conditions change.